Back to Skills

What Is Magnetic Declination and Does It Matter

What Is Magnetic Declination and Does It Matter
Survival Basics Team 18 March 2026

Maps refer to three different norths, and the differences between them have caused confusion, arguments and a fair number of navigation errors. In Britain the situation has recently become considerably simpler than it was for most of the last century.

What are the three norths?

True north is the direction of the geographic North Pole, the point about which the earth rotates. Grid north is the direction of the vertical grid lines on the map, which are a flat projection of a curved surface and therefore differ very slightly from true north. Magnetic north is where a compass needle points, governed by the earth magnetic field, and it moves continuously as that field shifts.

What is declination?

The angle between true north and magnetic north at a given place and time, also called magnetic variation. For practical navigation with an Ordnance Survey map, the useful figure is the angle between grid north and magnetic north, since grid north is what you measure bearings against and magnetic north is what your compass shows. Every OS sheet prints this in the legend along with the annual rate of change.

  • True north, the geographic pole
  • Grid north, the map vertical lines
  • Magnetic north, where the needle points
  • Declination, the angle between them, varying by place and year
  • The map legend states the current value and annual change

How much is it in Britain now?

Very little, which is a genuine change from historical practice. For most of the twentieth century, magnetic north in Britain sat several degrees west of grid north, and correcting for it was a routine part of navigation taught to every hill walker. The magnetic pole has been drifting steadily, and the line of zero declination passed across the British Isles during the 2010s. Across most of the country the difference is now within a degree or two, which is smaller than the error in a carefully walked bearing.

Does that mean you can ignore it?

For walking bearings in Britain, generally yes, but check rather than assume. The value differs slightly across the country and continues to change year on year, so a figure that is negligible now may not remain so, and an older map will state an outdated value. The legend on a current sheet is the authoritative answer for that area, and reading it takes ten seconds.

When does it genuinely matter?

Abroad, and over long distances. Declination exceeds twenty degrees in parts of North America and reaches far higher at extreme latitudes, where ignoring it makes navigation impossible. It also matters more the further you travel on a single bearing, since an angular error grows with distance. Two degrees over a kilometre is thirty five metres and rarely significant, while twenty degrees over ten kilometres is more than three kilometres and entirely significant.

How do you apply a correction?

By adding when going from map to ground where magnetic north is west of grid north, and subtracting when it is east. The traditional mnemonic is grid to mag add, mag to grid subtract, which applies to westerly variation. Because the sign flips depending on which side magnetic north sits, and Britain has recently crossed that line, blindly applying a remembered rule is now a source of error rather than accuracy.

What can throw a compass off locally?

Far more than declination does, in practice. Iron and steel in fencing, gates, vehicles, ice axes, phones, camera magnets and even some rucksack buckles will deflect a needle by tens of degrees at close range. Certain igneous rock formations produce local anomalies. Always take a bearing well away from metal objects and check that the needle settles consistently, because a compass held near a car bonnet is not measuring the earth field at all.

How do you set declination on a compass?

Better models have an adjustable declination scale, usually a small screw that rotates the orienting arrow independently of the housing. Set it once for the area and the compass then reads corrected bearings automatically, removing any need to add or subtract in the field. This is worth doing where the value is significant, and it is worth checking on a borrowed or second hand compass, since one left set for a different country will read consistently wrong.

Read the legend, apply what it says, and spend more attention on keeping steel away from the needle than on the declination itself.